Anchor Bond Garage Floor
Home Anchor Bond Products About Us Maintenance Contact Us

 

Home
Up

ANCHOR BOND GARAGE FLOOR SYSTEM

Consists of a Primer coat of Anchor Bond Water Base Primer and Two coats of Anchor Bond Chemical Resistant

ANCHOR BOND GARAGE FLOOR INSTALLATION INSTRUCTIONS

PREP:

  • Sweep entire area clean that will be coated.
  • Mix 1 part muriatic acid to 8 parts water (Always add acid to water).
  • Using a sprinkling can, apply to floor (Only do a few hundred feet at a time.)
  • The product is working if you see a yellow color accompanied by a rotten egg smell.

***If you do not see this you will have to go to a 5 to 1 ratio (Water to Acid) or even lower.***

  • Allow acid to work on its own. When it stops bubbling, scrub the floor with a stiff bristle broom.
  • Vacuum up the water and acid and repeat until the entire area has been washed with acid.
  • Wash with water twice (2) to make sure all acid is removed, and scrub each rinse.
  • Wet vac entire area.
  • Let stand over night to dry.

 PRIMER COAT:

  • Mix 1 Part of Water Base Primer Resin to 3 Parts of Water Base Primer Hardener
  • Mix thoroughly for one (1) to two (2) minutes.
  • Mix only what you can use.

 APPLICATION INSTRUCTIONS:

  • Using paint brush provided, brush around edge so you keep product off the wall.
  • Roll product down on floor using 3/8” nap roller (250 sq. ft. per gallon).
  • If texture is needed, as you roll down primer, go back while primer is still wet and seed floor to rejection.
  • Broadcast sand by throwing into air and letting it settle on its own.
  • Make sure you cover entire floor in sand. You will be able to sweep excess sand.
  • Use the concrete squares as a guide; do one square, then seed, then move onto the next.
  • Let cure for 6 hours.

 URETHANE COAT

  • Sweep Excess sand and vacuum floor to get all sand off.
  • Using paint brush provided, brush around edge so you keep product off the wall.
  • Mix 4 Parts Urethane Resin to 1 Part Urethane Hardener in bulking tools provided.
  • Again using concrete squares, roll down urethane, rolling from top of square to bottom of square, then work left to right.
  • Paint the entire area.

 2nd URETHANE COAT

  • Sweep floor clean.
  • Using paint brush provided, brush around edge so you keep product off the wall.
  • Mix 4 Parts Urethane Resin to 1 Part Urethane Hardener in bulking tools provided.
  • Again using concrete squares, roll down urethane, rolling from top of square to bottom of square, then work left to right.
  • Paint the entire area.

Back to Top